My setup…
I have created a door frame using a curve sop. On both sides of the walls I have added extra points so that i can pull out part of the wall. I then use polyextrude to create the wall with the side profile. This has all been placed in a HDA.

My issue…
In my HDA i am giving the artist the ability to use polybevel sepertaly for the ceiling, left wall and right wall. However, when i adjust one polybevel from the HDA, this creates new lines. now my other polybevel controls in the HDA no longer work correctly, because the lines setup in that polybevel have changed.

The answer???
I have tried the group sop but this is not working. Any ideas?

Thanks!
Ron Lindsey

bumper :shock:

Its difficult to debug your problem without posting up your HDA

r